UNIT 1. 45 INGS WALK SOUTH KIRKBY                                                                                                                            YOUR CONTACT  BILL EAGLESON

PONTEFRACT  WEST YORKSHIRE WF9 3DQ                                                                                                                    PHONE/ FAX         01535 657621

TELEPHONE 07836 524794                                                                                                                                                        MOBILE                  07 774 480335

FAX 01977 640448                                                                                                                                                                       E-Mail   billeagleson@yahoo.co.uk

 E-MAIL   sales@spartanlubes.co.uk


HA 505


An off white highly alkaline powder formulated for use as a soak and electrolytic cleaner for steel and brass prior to electroplating or vitreous enamelling. Based on a blend of caustic, silicates, and detergent additives which prevent re deposition of soil and extend bath life, Soak Clean MDA will remove a wide range of soils including coolant and forming lubricants., and contains surfactants considered to be >80% biodegradable when tested by the OECD screening test which satisfied EEC directives 82/242 and 82/243.



Use in a heated soak, or agitated tank. As heat is generated when the product is mixed with water, make up solutions by gradual addition to cold water. Use concentrations are dependant on the soil, and best results will be obtained at 60- 80C. Rinse thoroughly to avoid alkali bloom.


Appearance                                               Off white free flowing powder

Solubility                                                    Water soluble

Corrosive action                                        Corrosive to Aluminium, Zinc, Lead, and Copper Alloys.

pH of working solution                               Above 13.0



Soak Cleaning

Steel or Copper                                         25-30 grams per Ltr

Brass                                                        25-35 grams per Ltr


Electrocleaning                                      Use Cathodicaly at 60 grams per Ltr



Safety Advice  Corrosive contains Sodium Hydroxide, Substance identification No 1759 Causes severe burns. Wear suitable protective clothing Keep out of reach of children. Do not mix with other chemical products unless specifically directed.


First Aid  Wash splashes from the skin immediately with soap and water. If swallowed, DO NOT INDUCE VOMITING. give water to drink. Medical attention is recommended following eye contact, or if the product is swallowed. 

Spillage's Sweep up for re-use or disposal as waste. Spillage's of solution should be contained and absorbed with an inert mineral product.


  Home     Back to Cleaners