UNIT 1. 45 INGS WALK SOUTH KIRKBY YOUR CONTACT BILL EAGLESON
PONTEFRACT WEST YORKSHIRE WF9 3DQ PHONE/ FAX 01535 657621
TELEPHONE 07836 524794 MOBILE 07 774 480335
FAX 01977 640448 E-Mail email@example.com
A blend of non caustic alkalis and detergent additives which prevent re deposition of soil and extend bath life, formulated for use as a soak and electrolytic cleaner for steel and brass prior to electroplating or vitreous enamelling. Soak Clean-LDA will remove a wide range of soils including coolant and light duty forming lubricants., and contains surfactants considered to be >80% biodegradable when tested by the OECD screening test which satisfied EEC directives 82/242 and 82/243.
DIRECTIONS FOR USE.
Use in a heated soak, or agitated tank, make up solutions by gradual addition to cold water. Use concentrations are dependant on the soil, and best results will be obtained at 60-80C. Soak Clean LDA is also suitable for cleaning concrete floors.
Appearance Free flowing yellow powder
Solubility Water soluble
Corrosive action Hot highly concentrated solutions may be Corrosive to Aluminium, Zinc, and their Alloys.
pH of working solution 11.5
Steel or Copper 5-40 grams per Ltr
Brass 5-30 grams per Ltr
Electrocleaning Use Cathodicaly at 60 grams per Ltr
HEALTH AND SAFETY INFORMATION
Safety Advice Not classified as dangerous however the following safe working practices are recommended.
Avoid unnecessary prolonged personal contact. Keep out of reach of children. Do not mix with other chemical products unless specifically directed.
First Aid Wash splashes from the skin with soap and water. Following eye contact flush thoroughly with water. If swallowed, DO NOT INDUCE VOMITING. give water to drink. Medical attention is recommended following eye contact, or if the product is swallowed. Spillage's Sweep up for re use or disposal, Small spillage's of solution can be flushed to the foul sewer, large amounts should be absorbed with mineral absorbent, and collect for disposal.