UNIT 1. 45 INGS WALK SOUTH KIRKBY                                                                                                                            YOUR CONTACT  BILL EAGLESON

PONTEFRACT  WEST YORKSHIRE WF9 3DQ                                                                                                                    PHONE/ FAX         01535 657621

TELEPHONE 07836 524794                                                                                                                                                        MOBILE                  07 774 480335

FAX 01977 640448                                                                                                                                                                       E-Mail       bill.eagleson@virgin.net

 E-MAIL   sales@spartanlubes.co.uk



RP 820


Rust Guard WD is an invaluable maintenance product which cleans, dewaters, protects, and lubricates in one operation. Based on modern synthetic materials which give superior rust prevention properties it dries to a very thin ( 2 micron) oily film. Rust Guard WD has a pleasant characteristic smell and is suitable for use on all metals. Care should be taken with some plastic and rubber materials.




Use as supplied by aerosol, brush, non misting spray, or immersion



Appearance                        Clear brown liquid

Solubility                             Insoluble in water

Specific Gravity                    0.79

Flash point                          42c Pensky Martens closed cup.

Corrosive action                   None on metals but may effect some plastics or rubbers



Safety Advice

Flammable Substance identification No 1950 do not breath spray. Avoid unnecessary or prolonged personal contact, Keep out of reach of children.Do not mix with other chemical products unless specifically directed.


First Aid

Wash splashes from the skin immediately with soap and water. If swallowed, DO NOT INDUCE VOMITING. give water to drink. Medical attention is recommended following eye contact, excessive levels of vapour, or if the product is swallowed.



Spillage's should be contained and absorbed with an inert mineral product.


Additional information

Do not spray onto hot surfaces, live electrical equipment, or naked flame. All aerosol containers should be protected from sunlight and not exposed to temperature in excess of 55c. Aerosols should not be pierced or burnt even when empty.